zryouiki
-
Posts
5 -
Joined
-
Last visited
-
Days Won
6
Content Type
Profiles
Forums
Blogs
Gallery
Downloads
Articles
Media Demo
Events
Posts posted by zryouiki
-
-
On 6/30/2021 at 11:10 PM, chrapladm said:
So do you have Skrams or just Keystones?
2 of each.
On 7/1/2021 at 8:41 AM, Ricci said:Cool! Looks like a good time. Where are you located? That's a nice looking chunk of land.
The Keystones are bigger than I thought. What drivers do you have in them? What drivers in the Skram's?
Osborn Point out in the Cascades (Washington). Getting out there on the forest service roads is a bit of a challenge, especially with a ton of gear, but the vantage is amazing and you can make as much noise as you like way up there.
21DS115-4 in the Skrams. Keystones are loaded with some spare OEM ceramic, stamped basket 18s from a friend at a local, well known audio manufacturer. They're no B&Cs but they sim nicely and have stood up to some abuse that is frankly well past the specs I was given for them. They've got a good motor and great excursion capability. I think the excellent driver cooling of the Keystone design helps them stand up to the abuse.
- 3
-
Gig report- very impressed. I didn't have time to do proper measurements/EQ with a mic so I fiddled around in hornrep ahead of time to get a phase match with the keystones. Landed on delaying the Keystones 5.8ms with a phase invert. Based on the rich sound, coverage, and amp levels vs output, I think that must have been reasonably close. We had some issues maintaining voltage with the cable runs and generator capacity, and I was quite conservative running the NX6000 into them since I haven't set up proper limiting, but it was more than enough to prove these cabs are quite capable. Got the same excited feeling of bringing the system up to a brand new level as when I put together the Keystones. Of course, now I've got the itch to pair them with a Powersoft amp...
- 2
-
Some carpentry sins have been committed due to time constraints and lack of both quality tools and experience, but nothing I don't expect PL and Bondo to hide. It's an intimidating build to do by hand, mostly due to the bracing, but I wanted to do it "right" and I expect the cabinet is going to be stiff as hell. Got some 21DS115-4s on deck and if all goes well they'll be at full flex at an event last weekend in June.
- 4
-
Lavoce IPAL drivers
in Bass Gear
Posted
Well now they've got nominal 8ohm and super low <2ohm covered.
Would be nice if we could get SAN214.50 in 4ohm though.