I did. The old 7560's which I believe were the same as the Crown M600 and a couple of other re-badges. It's been a long time but it was something like 1500w burst into 4 ohm and 1000w for a very long time and would do it at 20Hz. Doesn't seem like much these days.
These aren't really amplifiers intended for "music" signals. These are industrial grade equipment for labs, measurements, running motors, MRI's, etc. HEAVY loads. They do audio just fine but are WAY overkill for bumping some music. Kinda like taking a Mack tri-axle dump truck to pick up 100lbs of mulch. I love how they rate their amps and provide all of the engineering specs. Compare their data sheets to those for Behringer or Yamaha amps. This is how gear used to be spec'd. I wish it still was. Amps really should be rated in terms of voltage and current capability into various loads at different frequencies IMHO. A 7810 or 7796 is a monster power source even if some 20lb amps produce more power on paper. The ratings are MUCH different. Yes they are heavy as hell. They have to be. You'll never get this type of ruggedness and sustained power output out of a 20lb amp.
If I was filthy rich I'd have a stack of these installed on 3 phase to run the subs, just because.