I've mentioned it a few times before. A pair of JBL 4675C's. The 2226H drivers out of the double 15" (4508A) bottoms I sold off and replaced with AE TD15M-4 drivers with the Apollo upgrade. They are wired in series. The big 2360A "butt" lenses still have the 2446H CD's on them. Those sit on top of the MAUL's. It is a tri-amplified stereo system run from a Peavey mixer into a DCX2496 which provides processing and routing to the amps. The current amps are a 20 year old Mackie M1400i on the 2446H drivers (Run from about 600Hz up.), a Crest 8002 powers the TD15M's which run about 80-600Hz roughly and a single SP2-12000 currently has a MAUL on each channel running <80Hz. There's no surround sound and I never replaced the old projector after it died a few years back so there is no video right now either. It's just a mammoth stereo or PA as needed. It's nothing special but does the job.
Eventually I planned to swap out the 2446H's for some BMS coax's or something Be and probably change the lenses too. Now I'm having thoughts of doing something different for the mids and highs entirely. Try to roll my own Synergy's or other design? Not sure what yet. I'll probably upgrade the amps first. Eventually I'll put my K20's one on each Maul and move to SP's at the house so I won't have to deal with fan noise at home anymore. I want to get a newer amp for the CD's. Only class AB or H for those though. I still don't think class D is quite as good for HF. I might just go with an A500. The power requirements on the CD's is almost nothing even at ear splitting levels.
The room is in an old rundown, warehouse / factory, in a ghetto part of town. Myself and the other musicians I work with, have been renting there for 8 years or maybe more. The whole building just about is rented out to musicians, artists or people needing storage. The outdoor test spot is right out the backdoor. The room itself is a shotgun shaped space about 18ft x 15ft x 36ft. Roughly 10,000cu ft. I'm guesstimating and could be off some, since I've never actually measured it. Walls are double carpet hung over sheetmetal and studs with main building supports in there too. Flimsy and leaky as hell but the carpet hanging from the walls and the directivity of the horns actually keeps the space relatively dead. Every surface in the room except for the garage style door and the ceiling are covered in carpet. The room is over the basement level, but the floors are 4 to 5 inch thick cement type material over timbers, so it will shake some, but not easily like a suspended floor in a house. It takes a bit more energy. Ceiling is the same deal. Back wall is a brick interior wall with carpet over it. The back ground noise level is high usually of course. There are no placement options really as the room is jam packed with equipment of all sorts. It is not ideal and there are all sorts of acoustic and structural issues that color the sound. For one my drums usually sit directly in front of one side of the stack. Thankfully the horns are 8 or 9 ft off the floor well over top of them and the bass just goes around, so most of the sound ends up in the right place regardless. None of that matters really because that's not what it's about in there anyway.